High Quality Tungsten Carbide 1/2 Inch Shank Finger Joint Assembly Router Bits for Wood Working

1.With its wedge-shaped multiple interlocking fingers, this fine finger joint bit creates a maximum gluing surface area for superior edge joints and splice joints and helps to minimize gaps when routing edge joints and even end grain to end grain.

2.Using this bit couldn't be simpler. You will start by centering your bit to the stock. Position your router fence even with the outside edge of the bearing on the bit. Rout one board face up and the next face down. Keep alternating until all of your stock is routed.

3.Industrial quality two-flute C3 tungsten carbide cutters, solid hardened steel body and 1/2” thick shank. Ideal for joining wood edge-to-edge or end-to-end, because the joint produced is stronger than the wood itself.

4.Cuts all composition materials including plywoods, hardwoods and softwoods from 5/16” to 1-1/4” in thickness.

5.Anti-kickback design, build-up resistant TPFE coating and a guide bearing. Router table use only. Not for free hand routing.